Nolina Vase Plaster Mold
A 2-piece plaster casting mold designed for producing decorative and artistic ceramic pieces in the modern and distinctive Nolina vase form. Two different vase sizes, large and small, can be produced from the mold. The mold can be used with earthenware, ceramic, stoneware, and porcelain casting slips.
Plaster Mold Information
Plaster Mold Dimensions 36,5 × 15 × 37,5 cm
Number of Mold Pieces 2 Pieces
Production Method Slip Casting
Mold Weight: The weight of the mold may vary depending on its moisture content. An approximate variation of ±%10 in weight may occur.
Large Size
Finished Product Dimensions 25 × 6,5 × 25 cm
Opening Diameter 6 cm
Finished Product Weight 1350 gr (±%2)
Small Size
Finished Product Dimensions 18 × 4,5 × 18 cm
Opening Diameter 3,5 cm
Dimension Information: The finished product dimensions are measured from the ceramic bisque piece. Final product dimensions and weight may vary depending on the shrinkage rate of the clay and the firing temperature.
Compatible Clays
The mold can be used with earthenware, ceramic, stoneware, and porcelain casting slips. The wall thickness and casting time may vary depending on the characteristics of the clay used.
A fuller wall thickness is generally preferred with ceramic and earthenware casting slips. Stoneware and porcelain casting slips, when used with suitable formulations and casting conditions, are suitable for producing thinner forms. With suitable porcelain bodies in particular, very thin castings with light-transmitting translucency can be achieved.
Warning: Not suitable for stone powder, plaster, concrete, resin, or similar non-ceramic casting materials.
Usage and Drying
- The casting slip should be poured into the mold in a controlled manner.
- It is recommended to mix the casting slip thoroughly until homogeneous before casting.
- To ensure the body and opening details of the Nolina vase form evenly, the casting slip should be distributed consistently throughout the mold.
- Depending on ventilation and drying conditions, an average of 2–4 castings can be made per day.
- The mold should be allowed to dry sufficiently between castings.
Wet Mold Warning: Depending on production intensity, the mold may occasionally be shipped while still damp or wet. In this case, it should be left to air-dry naturally for 1–2 days in a well-ventilated area before use.
Minor deformation may occur on the outer surface, edges, or corners of the mold during transportation. The mold can still be used as long as there is no damage to the internal casting surface that would affect the finished product or interfere with the casting process.
Mold Lifespan: Approximately 100 castings on average. This may vary depending on the clay used, casting frequency, drying conditions, and method of use.