```
Hookah Bowl Double Battery Plaster Mold
A 3-piece, double battery-type plaster casting mold designed for producing
ceramic hookah bowls. Thanks to its two separate product cavities, it allows
the production of 2 hookah bowls in a single casting, making the production
process more efficient. It can be used with earthenware, ceramic, stoneware,
and porcelain casting slips.
Plaster Mold Dimensions
32 × 16 × 19 cm
Finished Product Length
11 cm
Opening Width
8 cm
Body Diameter
3,5 cm
Production Capacity
2 Pieces per Casting
Mold Weight
8 kg (±%10)
Number of Mold Pieces
3 Pieces
Double Battery Mold:
The mold contains two separate product cavities. Thanks to this structure,
2 hookah bowls can be produced simultaneously
in each casting operation.
Dimension Information:
The finished product dimensions are measured from the ceramic bisque piece.
Final product dimensions may vary depending on the shrinkage rate of the clay
and the firing temperature.
Compatible Clays
The mold can be used with earthenware, ceramic, stoneware, and porcelain casting slips.
The wall thickness and casting time may vary depending on the characteristics of the clay used.
A fuller wall thickness is generally preferred with ceramic and earthenware casting slips.
Stoneware and porcelain casting slips, when used with suitable formulations and casting conditions,
are suitable for producing thinner forms.
Warning:
Not suitable for stone powder, plaster, concrete, resin, or similar
non-ceramic casting materials.
Usage and Drying
- The casting slip should be poured into both product cavities in a controlled manner.
- It is recommended to mix the casting slip thoroughly until homogeneous before casting.
- Depending on ventilation and drying conditions, an average of 2–4 castings can be made per day.
- Each casting operation can produce 2 ceramic bisque pieces simultaneously.
- The mold should be allowed to dry sufficiently between castings.
Wet Mold Warning:
Depending on production intensity, the mold may occasionally be shipped
while still damp or wet. In this case, it should be left to
air-dry naturally for 1–2 days in a well-ventilated area
before use.
Minor deformation may occur on the outer surface, edges, or corners
of the mold during transportation. The mold can still be used as long as
there is no damage to the internal casting surfaces that would affect
the finished products or interfere with the casting process.
Mold Lifespan:
Approximately 100 castings on average. This may vary depending on the clay used,
casting frequency, drying conditions, and method of use.
```