Hamsa Plaster Mold
Hamsa Plaster Mold

Hamsa Plaster Mold


Mold Size: 24 x 26 x 6 cm (Width x Length x Depth)
Product Dimension: 13 x 17.5 cm (Width x Length)

 

Product information:
It consists of one piece. (Tab Tab)
You can produce easier and faster with the method of tab tab (putting the mud on it and hitting - pressing - pressing by hand).
Production can also be made with the casting method, but it will take much longer than the tab tab method.
The back is flat and suitable for hanging on the wall.
The shrinkage rates of the casting slip to be poured in may vary depending on whether it is ceramic or porcelain.
It is suitable for casting ceramic or porcelain clay.
If the edges of the mold are broken or damaged, it does not prevent getting a smooth product from it. The important part is that the inside of the mold is smooth.
The plaster mold should be wiped with a damp sponge before casting, and care should be taken to avoid dust and particles.
The casting slip should be mixed thoroughly with the help of an electric mixer if possible, or a wooden spoon.
The casting slip to be put in should be prepared a day before  in advance and sodium silicate (glass water) should be used during the preparation stage.
The slip should be poured into the mold slowly and filled up to the rim of the mold.
Depending on the weather conditions, 2-4 castings can be made per day.
The lifetime of the product is about 100 castings. It may vary depending on usage.

cultureSettings.RegionId: 0 cultureSettings.LanguageCode: EN